Maintaining the Supervisor in the Cisco cBR Chassis
Figure 135: Removing the 40-Gigabit QSFP+ or 100-Gigabit QSFP28 Transceiver Module
Step 4
Place the QSFP+ or QSFP28 transceiver module into an antistatic bag.
What to do next
Replace the QSFP+ or QSFP28 module
Removing the Supervisor PIC Cable Management Bracket
The Supervisor PIC cable management bracket is usually removed when the Supervisor PIC needs to be
replaced.
Before you begin
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
• Remove all the cables that are routed through the Supervisor PIC cable management bracket.
Required Tools and Equipment
• ESD-preventive wrist strap
• 3/16" flat-blade screwdriver
Step 1
Loosen the two captive screws that secure the Supervisor PIC cable management bracket using a 3/16" flat-blade
screwdriver.
connected to the chassis.
Removing the Supervisor PIC Cable Management Bracket
(if required).
Cisco Converged Broadband Routers Hardware Installation Guide
211