Installing the Supervisor in the Cisco cBR Chassis
1
Strap-down clip
2
RJ-45 cable bundle
3
Cable tie
Figure 93: Routing the RJ-45 Cables Connected to the Supervisor PIC Option 3
1
Strap-down clips
2
RJ-45 cable bundle
Step 3
Repeat
Step 1, on page 102
Using the USB Port on the Supervisor Card
Before you begin
•
•
Restrictions
The USB ports on the Supervisor Card are used for temporary connections. For all permanent connections,
you must use the ports on the Supervisor PIC.
Required Tools and Equipment
and
Step 2, on page 104
Install the Supervisor
PIC.
Install the Supervisor
Card.
4
Supervisor PIC cable management bracket
5
Snap-on plastic fiber/cable routing guides
—
3
Cable ties
4
Supervisor PIC cable management bracket
for the cables connected to the each Supervisor PIC.
Cisco Converged Broadband Routers Hardware Installation Guide
Using the USB Port on the Supervisor Card
129