Installing the Fan Module in Cisco cBR
Figure 37: Aligning the Fan Module
Step 2
Tighten the captive screws on front left flange of the Fan Module.
To tighten the captive screws on the Fan Modules, apply 6-8 in-lb (0.67-0.90 Nm) torque.
Note
What to do next
• Visually check if the fans are working.
• If the RPLC LED on the Fan Module faceplate is illuminated, see
section for corrective action.
Cisco Converged Broadband Routers Hardware Installation Guide
Installing the Fan Module in the cBR Chassis
Troubleshooting the Fan Assembly
75