Table of Contents
Advertisement
Installing the Supervisor in the Cisco cBR Chassis
Step 2
Pull the spring-loaded ejectors on the card until they release and are perpendicular to the faceplate.
Step 3
Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight.
Step 4
Carefully align the support rails on the card with the rails in the appropriate slot.
Step 5
Slide and push the card into the slot applying even pressure using both your hands until it mates with its midplane
connectors.
Caution
To prevent damage to the midplane connector, do not use excessive force when inserting the card into the slot.
Figure 78: Inserting the Supervisor Card into the Chassis
Step 6
Simultaneously pivot both the spring-loaded ejectors towards the faceplate until they make contact with the faceplate.
Installing the Supervisor Card in the Cisco cBR Chassis
Cisco Converged Broadband Routers Hardware Installation Guide
117
Advertisement
Table of Contents
Troubleshooting
