Using The Auxiliary Port On The Supervisor Pic - Cisco cBR Series Hardware Installation Manual

Installing the Supervisor in the Cisco cBR Chassis

Using the Auxiliary Port on the Supervisor PIC

The auxiliary port provides a connection for a terminal server to allow remote access to the router and its
command-line interface (CLI).
Before you begin
•
•
Required Tools and Equipment
• RJ-45 cable
• RJ-45-to-DB-9 adapter
• Terminal server
Step 1 Connect one end of the RJ-45 cable to the auxiliary port on the Supervisor PIC.
Figure 59: Auxiliary Port Connection on the Supervisor PIC
Step 2 Connect the other end of the RJ-45 cable to the RJ-45-to-DB-9 adapter.
Figure 60: Connecting an RJ-45-to-DB-9 Adapter
Step 3 Connect the RJ-45-to-DB-9 adapter to the appropriate serial port on the terminal server.
What to do next
Route the cable through the Supervisor PIC cable management bracket and chassis-mounted fiber/cable routing
guide.
Install the Supervisor PIC.
Install the Supervisor Card.
Cisco Converged Broadband Routers Hardware Installation Guide
Using the Auxiliary Port on the Supervisor PIC
101