Cisco cBR Series Hardware Installation Manual page 101

Installing the Supervisor in the Cisco cBR Chassis
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
• You must use the supported SFP+ modules. The following SFP+ modules are supported on the Supervisor
Required Tools and Equipment
• ESD-preventive wrist strap
• SFP+ module
Step 1 Remove the SFP+ module from its protective packaging.
Do not remove the optical bore dust plugs.
Note
Figure 48: SFP+ Module with Dust Plugs
1 Dust plug
2 Bail clasp with clasp tab
Step 2
Check the label on the SFP+ module to verify that you have the correct model for your network.
Step 3 Find the send (TX) and receive (RX) markings that identify the top side of the SFP+ module.
On some SFP modules, the TX and RX marking might be replaced by arrowheads pointing from the SFP+
Note
module connector (transmit direction or TX) and towards the connector (receive direction or RX).
Step 4
Align the SFP+ module in front of the socket opening.
Step 5 Carefully insert the SFP+ module into the socket until you feel the connector latch into place.
connected to the chassis.
PIC:
• SFP-10G-SR
• SFP-10G-LR
• SFP-10G-ER
• SFP-10G-ZR
• SFP-10G-LRM
Installing the SFP+ Modules in the Supervisor PIC
3 Transmit bore
4 Receive bore
Cisco Converged Broadband Routers Hardware Installation Guide
93