Cisco cBR Series Hardware Installation Manual page 116

Using the Console Port on the Supervisor Card
Required Tools and Equipment
• Console cable (with mini type-B USB connector on one end, and a type-A USB connector on the other
• Exar XR21V1410 UART with USB interface
• Cable with type-A USB connector on one end and DB-9 connector on the other end
• PC or terminal
Step 1
Open the tethered I/O door on the Supervisor Card by pulling on the left edge of the door until the door is released from
the spring-loaded ejector.
Figure 69: Opening the Tethered I/O Door on the Supervisor Card
1 Tethered I/O door
Step 2 Connect the mini type-B USB connector of the console cable to the console port on the Supervisor Card.
Figure 70: Console Port Connection on the Supervisor Card
1 Mini type-B USB connector
Cisco Converged Broadband Routers Hardware Installation Guide
108
end)
Installing the Supervisor in the Cisco cBR Chassis
—
2 Console cable (with mini type-B USB connector
on one end, and a type-A USB connector on the
other end)