Removing The Supervisor Pic From The Cisco Cbr Chassis - Cisco cBR Series Hardware Installation Manual

Removing the Supervisor PIC from the Cisco cBR Chassis

Figure 136: Removing the Supervisor PIC Cable Management Bracket
1 Captive screws
Step 2
Remove the Supervisor PIC cable management bracket.
What to do next
Replace the cable management bracket
Removing the Supervisor PIC from the Cisco cBR Chassis
Perform this procedure to remove the following PIC:
• Supervisor PIC
• Blank PIC for the Supervisor
Before you begin
Caution • In a Cisco cBR with 1+1 Supervisor redundancy, removing the active Supervisor Card or Supervisor
• In a Cisco cBR with 1+1 Supervisor redundancy, removing the standby Supervisor Card or Supervisor
• In a Cisco cBR without Supervisor redundancy, removing the Supervisor Card or Supervisor PIC results
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
• Disconnect all the cables from the Supervisor PIC.
• Be aware of the weight and size of the equipment. Handle it with care.
Cisco Converged Broadband Routers Hardware Installation Guide
212
PIC results in switchover.
PIC may result in limited packet loss in the active-active backhaul configuration.
in complete loss of service.
connected to the chassis.
Maintaining the Supervisor in the Cisco cBR Chassis
2 Supervisor PIC cable management bracket
(if required).