Cisco cBR Series Hardware Installation Manual page 88

Installing the FPEM in the Cisco cBR Chassis
Before you begin
•
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
• Be aware of the weight and size of the equipment. Handle it with care.
Required Tools and Equipment
• ESD-preventive wrist strap
• AC or DC FPEM
• T10 Torx torque screwdriver
Step 1 Remove the four #6-32 Torx-head screws located on the chassis mounting flanges using a T10 Torx torque screwdriver.
Step 2
Carefully slide the FPEM into the slot using the two handles applying even pressure to both the handles until the FPEM
is fully seated in the chassis.
To prevent damage to the midplane connectors, do not use excessive force when inserting the FPEM into the
Caution
slot.
Figure 40: Installing the FPEM in the Chassis
Cisco Converged Broadband Routers Hardware Installation Guide
80
Install the Power Cassette Module.
connected to the chassis.
Installing the Power System in the Cisco cBR Chassis