Installing the Interface Line and PIC Cards
• Be aware of the weight and size of the equipment. Handle it with care.
Restrictions
• Install the interface line card in the slot corresponding to the Digital Protect or Digital Through PIC
Required Tools and Equipment
• ESD-preventive wrist strap
• 3/16" flat-blade torque screwdriver
• One of the following SSI Cards (line cards):
Step 1
Loosen the captive screws on the appropriate slot using a 3/16" flat-blade torque screwdriver until the red bands are
visible on the captive screws.
Ensure that the red band on the screws are visible.
Note
Figure 110: Red Band on the Screw
Step 2
Pull the spring-loaded ejectors on the card until they release and are perpendicular to the faceplate.
installed.
• DOCSIS MAC line card (40G) [PID: CBR-CCAP-LC-40G]
• DOCSIS MAC line card (80G) [PID: CBR-CCAP-LC-G2-R]
• Line card blank. [PID: CBR-LC-BLANK]
Installing the DOCSIS MAC Interface Line Card in the Cisco cBR Chassis
Cisco Converged Broadband Routers Hardware Installation Guide
153