Cisco cBR Series Hardware Installation Manual page 202

Removing the FPEM from the Cisco cBR Chassis
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
•
• If you are replacing the entire power system,
• Be aware of the weight and size of the equipment. Handle it with care.
Required Tools and Equipment
• ESD-preventive wrist strap
• T10 Torx screwdriver
• Antistatic bag
Step 1
Loosen and remove the four #6-32 Torx-head screws on the mounting flanges of the FPEM using a T10 Torx screwdriver.
Figure 120: Removing the FPEM from the Chassis
Step 2 Slide the FPEM out of the chassis using the handles on either side applying even pressure to both handles.
Step 3 Place the removed FPEM in an antistatic bag.
Cisco Converged Broadband Routers Hardware Installation Guide
194
connected to the chassis.
Remove the Power Modules.
Maintaining the Power System in the Cisco cBR Chassis
remove the Power Cassette Module.