Cisco cBR Series Hardware Installation Manual page 75

Installing the Cisco cBR Chassis
• Strap down cable bundles or conduit (there are multiple tie-down points on each strap-down clip).
• A base for two snap-on plastic fiber or cable routing guides.
Before you begin
Required Tools and Equipment
• 4 knurled retaining screws
• T15 Torx driver (optional)
• 2 strap-down clips
• 4 snap-on plastic cable routing guides
Step 1 Insert the four knurled retaining screws on the side of the chassis and tighten them using a T15 Torx driver (up to a torque
of 6 to 8 in-lb).
If the screw location is not accessible for a driver, you can tighten the knurled screws by hand.
1 Knurled retaining screws
Attaching the Fiber or Cable Routing Guide on Chassis
—
Cisco Converged Broadband Routers Hardware Installation Guide
67