Cisco cBR Series Hardware Installation Manual page 86

Installing the Power Cassette Module in the Cisco cBR Chassis
Figure 38: Removing the Front Power Entry Bezel from the Chassis
1 Screw
Step 2
Remove the four #6-32 Torx-head screws located on the chassis mounting flanges using a T10 Torx torque screwdriver.
Step 3 Slide the Power Cassette Module into the slot in the chassis until the mounting flanges are fully seated.
Cisco Converged Broadband Routers Hardware Installation Guide
78
Installing the Power System in the Cisco cBR Chassis
2 Front power entry bezel