Removing The Digital Pic From The Cisco Cbr Chassis - Cisco cBR Series Hardware Installation Manual

Maintaining the Interface Cards in the Cisco cBR Chassis
Figure 148: Removing the Interface Card from the Slot
Step 4
Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight, and remove
the card from its slot.
Step 5
Place the removed card in an antistatic bag.
Note If a line card blank is removed, it need not be placed in an antistatic bag.
Note Close the spring-loaded ejectors before placing it in the anti-static bag.
What to do next
•

Removing the Digital PIC from the Cisco cBR Chassis

Before you begin
• Before removing an Digital PIC, ensure that one of the following cards is available for immediate
Replace the Interface Line Card or install a line card blank
replacement in the chassis:
• replacement Digital Through PIC or Digital Protect PIC
• PIC Blank
Removing the Digital PIC from the Cisco cBR Chassis
(as required).
Cisco Converged Broadband Routers Hardware Installation Guide
225