Figure 73: Removing The Dust Cover From An Sfp+ Transceiver; Figure 74: Positioning The Sfp+ Handle In The Upright Position - Allied Telesis x330 Series Installation Manual
Fanless gigabit layer 3 access switch virtual chassis stacking
Hide thumbs
Also See for x330 Series:
- Installation manual (126 pages) ,
- Installation manual (172 pages)
Table of Contents
Advertisement
Figure 73. Removing the Dust Cover from an SFP+ Transceiver
6. Verify that the transceiver handle is in the upright position. Refer to
Figure 74.
SFP+ Handle
Figure 74. Positioning the SFP+ Handle in the Upright Position
7. Connect the fiber optic cable to the transceiver. Refer to Figure 75 on
page 144. The cable connector should fit snugly into the port, and the
tab should lock the connector into place.
x330 Series Installation Guide for Virtual Chassis Stacking
143
Advertisement
Table of Contents
