Table of Contents
Advertisement
ASSEMBLY
Seed Shaft Sensor Console and
Harness Installation
1. If equipped with Clutch Switch Bar, remove from
Tractor and remove Clutch Harness from Seeder.
2. Mount Seeder Console with Clutch Control on
Tractor.
3. Route Console Harness with 9 Pin Connector to the
Seeder Harness.
4. Attach 3 Pin Power Plug to Tractor.
5. Secure Console Harness with Tie Wraps.
2-26
Figure 2-33: Seed Shaft Sensor Schematic
6. Route Seeder Harness along Frame of Seeder.
Ensure plug labeled Electric Clutch Power is on the
left side.
7. On left side connect plug labeled "Electric Clutch
Power" to the Electric Clutch Lead. See Figure 2-33.
8. Connect plug labeled "Left Front Seed Shaft Sensor"
to the left front Seed Shaft Sensor. Seal the plug end
using a 3-Pin Tower and Cavity Plugs to protect it
from the environment.
9. Repeat for the right side.
10. Secure all Harnesses with Tie Wraps.
9K998
Advertisement
Table of Contents
