Table of Contents
Advertisement
Transmission 01/2020 and Prior
On the back of the Transmission by the Calibration
Wrenches, loosen the Transmission #40 Drive Chain
Idler Sprocket Axle Bolt to adjust the Drive Chain
Tension. Tighten or loosen the Clevis Drawbolt Locknut
to obtain about 1/8" - 1/4" Slack. Re-tighten the Idler
9K998
Figure 4-5: Transmission 01/2020 and Prior
Sprocket Axle Bolt. Be careful not to over-tighten this
Chain. Figure 4-5.
#550 Drive Chain between the Front Roller Sprocket and
Transmission Clutch Shaft should have approximately 2"
of total deflection. Loosen the Nylatron Tension Idler and
adjust accordingly.
MAINTENANCE
4-7
Advertisement
Table of Contents
