Tire And Wheel Installation - Landoll BRILLION TURFMAKER II SL Operator's Manual

6. Apply anti-seize to Spindles and insert a Hub and
Spindle Assemblies into each Wheel Arm. Secure in
Spindles farthest hole from the Hub with 1/2-13 x 3
Bolts and Locknuts. See Figure 2-7.

Tire and Wheel Installation


Use a torque wrench to assure proper torque.
Insufficient torque can cause stud breakage and
damage the wheel pilots. Over torque can stress
the Bolts and strip the threads.
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward from Hub and Spindle.
IMPORTANT
Torque will drop after the first 10 hours of operation.
Check the Wheel Bolts for proper torque after this
interval and re-tighten them.
• 8Ft Seeder uses 9.5L x 15, 8Ply Implement Rib
Rating Tires and should be inflated to 44 PSI.
• 10Ft Seeder uses 11L x 15, 12Ply Implement Rib
Rating Tires and should be inflated to 52 PSI.
9K998
Figure 2-7: Hub and Spindle
WARNING
• Install a Tire and Wheel Assembly onto each Hub
with 1/2-20 x 1 Wheel Bolts and tighten Wheel Bolts
to 50 ft-lbs using the sequence in Fig 2-8. Then
tighten to a full torque of 80-85 ft-lbs.
Figure 2-8: Tightening Sequence
ASSEMBLY
2-5