Hitch Installation - Landoll Coulter Chisel 2112 Operator's Manual

ASSEMBLY INSTRUCTIONS

Hitch Installation

1. Attach the hitch assembly to the front of the center
frame using hitch pins, 1" lock nuts, and 1/2 x 2-1/4
groove pins See Figures
NOTE
Hitch is weighted, use a sufficient device for lifting
and installing hitch assembly.
2. Move the jack to the forward mounting tube and
rotate to parking position to support the front of the
hitch.
3. Attach the hose clamps, 3-8 x 3-1/2 bolt, 3/8 flat
washer and 3/8 lock nut to plate on rear of hitch.
4. Remove the 1 x 11 bolt from hitch assembly and
install the hose storage plate in position shown
Figures 3-7, re-install the 1 x 11 bolt, 1 flat washer
and 1 lock nut.
3-8
3-7.
See
5. Install the hose holder bracket to the front of the hitch
assembly with 3/4 x 2 bolt, 3/4 flat washer and 3/4
lock nut.
6. Install the stor-a-way to the hose holder bracket with
1/4 x 1 bolts and 1/4 lock nuts.
7. Attach the hose clamp long, wing nut and 3/8 x 5 all
thread bolt. Install the 3/8 x 5 all thread bolt and
thread on 3/8 nut to secure bolt to hose holder
bracket.
IMPORTANT
The clamp has two sides, so that extend hoses can
be located on one side and retract hoses can be
located on the other side for reference.
F-1102-0721