Landoll BRILLION TURFMAKER II SL Operator's Manual page 44

ASSEMBLY
11. Remove the Mount Plate Hardware and slide the LH
Seed Box far enough to the right to remove the
Mount Plate from the Seed Box and Transmission.
Complete removal of the Seed Box is not required,
the Seed Shaft will slide in the 37 Tooth Sprocket
and Bearing. Remove the Single Box Mount Plate
and replace it with a Double Box Mount Plate on the
Transmission and LH Seed Box ensuring that the
Seed Shaft is aligned and free to rotate. Tighten
Hardware.
12. Remove Transmission Shield, Sprocket Cover and
2-Hole Cover from Transmission. See Figure 2-38.
13. Disassemble Hex Bore Bearing from Sprocket Cover
and assemble it onto the outside of Sprocket Cover
Weldment (surface opposite channel). Do not tighten
at this time. See Figure 2-39. Assemble Idler
Sprocket onto Sprocket Cover Weldment Channel
with 5/8-11 X 2-1/4 Bolt, Flat Washers, 5/8- x 1 x
14ga Washers, Lock Washer and Nut. Do not tighten
at this time. Mount Sprocket Cover Weldment on
Transmission while sliding Hex Bore Bearing onto
Front Seed Shaft. Check Idler Sprocket alignment
with Jackshaft Sprocket and adjust 5/8 x 1 x 14ga
Washers accordingly. Ensure that the Front Seed
Shaft is aligned and free to rotate, tighten Hardware.
2-28
14. Install 3/4 Bearings and Flangettes on Transmission
Figure 2-39: Rear Box Transmission
Figure 2-38: Transmission Shield
with 5/16-18 x 1 Bolts, Lock Washers and Nuts. Do
Not Tighten at this time.
9K998