Remove A Sensor; Add A Sensor - Landoll Brillion SS108 Operator's Manual

Settings Menu -
Install Setup
Select "Install Setup" icon to Learn New System, Add A
Sensor, or Remove A Sensor to your machine.
INSTALLATION
LEARN NEW
SYSTEM
Learn New System
Select "Learn New System" if
your monitor did not come
pre-programmed or you wish to
relearn all sensors.
1. Start by unplugging all sensors on the implement and
then selecting "Learn New System". A popup will
warn you that all current sensors will be overwritten.
Select "Yes, Learn New System".
2. Refer to Brillion Elite Mini Monitor Electrical
Schematic for Sensor Locations. See Figure 2-25.
The monitor will prompt "Plug In Sensor" (all
sensors have a 3-Pin Connector with white, black
and green wires) in the following order. The sensor
being prompted will automatically be learned upon
connecting the 3-Pin Connector.
• "Plug In Sensor - Speed" Ground Speed Smart
Shaft Sensor is installed on the Seeder Clutch
Shaft.
• "Plug In Sensor - Clutch Box" Clutch Smart
Relay installed in the Elite Mini Tractor Harness
• "Plug In Sensor - Shaft 1-6" Up to six Seed
Shaft Smart Shaft Sensors can be installed.
• "Plug In Sensor - Bin 1-6" Up to six Bin Level
Sensors can be installed.
3. It is likely your system will not be configured for the
maximum possible sensors or even certain types of
sensors the Loup Elite is capable of.
Use the "Skip this Sensor"
button to advance ahead one
sensor at a time.
Use the "Skip this Type of
Sensor" to advance to the
next category of sensors.
4. When you've reached the end of the list of sensors,
you will be prompted with "Manual Learn
Complete". Push "Ok" to finish.
9K713-0522
TABLE OF CONTENTS
INSTALL
SETUP
BACK
REMOVE A ADD A
SENSOR SENSOR
LEARN NEW SHAFT
SYSTEM SENSOR
SKIP THIS
SENSOR
SKIP THIS TYPE
OF SENSOR
BRILLION ELITE MINI MONITOR

Remove A Sensor

Select this option to remove a
sensor from your existing system.
1. Select the type of sensor you wish to remove.
REMOVE A SENSOR
SHAFT
SENSOR
HOPPER
LEVEL
SMART
RELAY BOX
2. Use the Left and Right Arrows to navigate to the
sensor number you wish to remove.
3. Select the "Remove A Sensor" button to complete
the removal.
REMOVE A SENSOR
SPEED

Add A Sensor

Select this option to add a new
sensor to your existing system.
1. Select the type of sensor you wish to add.
ADD A SENSOR
SHAFT
SENSOR
HOPPER
LEVEL
SMART
RELAY BOX
2. Use the Left and Right arrow buttons to navigate to
the sensor number you wish to add.
3. Select the "Add A Sensor" button to complete the
sensor addition.
ADD A SENSOR
SPEED
REMOVE A
GPS
SENSOR RECEIVER
BACK
GROUND
SPEED
LIFT
SWITCH
REMOVE A
SENSOR
ADD A
SENSOR
BACK
GROUND
SPEED
LIFT
SWITCH
ADD A
SENSOR
4-5