Table of Contents
Advertisement
ASSEMBLY
Pull Type Seeder Assembly, 8Ft
and 10Ft
When shipped, Seeder comes assembled except for
Lights, Hub and Spindle Assemblies, Tire and Wheels
Assemblies and Drawbar.
1. Untie the two rolled up Drawbar Hydraulic Hoses
near the center of the Frame Tube. Ensure the hoses
are not interfering with where the Drawbar is to be
attached.
2. Center
Drawbar
in relationship with the Seed Box
Center Bracket. Attach
Tube with 5/8-11 U-Bolts, Lock Washers and Nuts.
See Figure 2-6.
3. Attach the Hose Holder to the Drawbar with 5/8-11 x
1-1/2 Bolt, Lock Washer and Nut.
4. Install Manual Holder to Drawbar with Hose Clamps.
5. Install SMV Support to Seed Box Center Bracket with
3/8-16 x 1-1/2 Bolts, Flat Washers, Lock Washers,
and Nuts. See Figure 2-5.
2-4
Drawbar
to Seeder Frame
Figure 2-6: 8Ft and 10Ft Drawbar
Figure 2-5: SMV Support
9K998
Advertisement
Table of Contents
