Seed Shaft Sensor Kit - Optional - Landoll BRILLION TURFMAKER II SL Operator's Manual

ASSEMBLY

Seed Shaft Sensor Kit - Optional

Seed Shaft Sensor and Magnet Wheel Assembly
Installation
1. Remove the two #10-24 x 3/4" Self Tapping Screws
from the Magnet Wheel Assembly.
2. Position half of the Magnet Wheel Assembly on the
Seed Shaft. Ensure it fits squarely onto Seed Shaft.
3. Mount the other half, ensuring it fits squarely onto
Seed Shaft.
2-24
Figure 2-31: Seed Shaft Sensor Brackets
4. Fasten the two halves together using two #10-24 x
3/4" Self Tapping Screws. Do not over tighten.
5. Identify the Seed Meters on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware.
6. Insert Seed Shaft Sensor into Shaft Sensor Bracket
Slot. See Figure 2-31.
7. Align the Shaft Sensor Bracket with the two 1/4-20
Bolts. Secure with existing Lock Washers and Nuts.
8. Position Seed Shaft Sensor so it is 1/8" from the
Magnet Wheel Assembly. See Figure 2-32. Tighten
both Seed Shaft Sensor Retaining Nuts.
9K998