Table of Contents
Advertisement
Tractor Preparation/Attaching of
Pull Type Seeder
Do not allow any bystanders to stand between
the tractor and the implement while backing up to
the implement.
1. Align the Tractor Drawbar with the machine. Raise or
lower the Drawbar, as needed, using the Jack.
Attach the unit with proper size Hitch Pin and Safety
Clip.
2. Always move the Jack to the transport position
before setting the machine in motion.
3. Clean all Hydraulic Couplings and attach to the
Tractor.
4. If Transport Locks are not engaged, fully extend the
Hydraulic Lift Cylinders and rotate Transport Locks in
the engaged position over the Cylinder Rods. Secure
with the Clevis Pins and Hairpin Cotters. See
Figure 3-5.
IMPORTANT
If the Clevis Pin is not installed, the Transport Lock
may bounce up and cause significant damage to the
Cylinder and Hydraulic Fittings.
Figure 3-5: Transport Lock Engaged
5. Attach safety chain to tractor allowing plenty of
movement for turning both directions. The safety
chain should latch securely to prevent it from coming
loose. See Figure 3-6.
9K998
DANGER
Figure 3-6: Safety Chain
6. Plug the 7 Pin Connector to Tractor Outlet, routing
cable by avoiding pinch points.
• Make sure the Tractor has a good clean Receptacle,
free of dirt and corrosion.
• Make sure the 7 Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think
the Connector is all the way in, but really isn't.
• Make sure the Tractor Receptacle Cover latches
over the keyway on the 7 Pin Connector to hold the
Connector in place.
• If an operator plugs in the 7 Pin Connector, but the
lights do not seem to work right, check the above
items to make sure there is a good connection with
the 7 Pin Connector.
7. Install Clutch Switch and Harness. See
"Transmission Electric Clutch" on page 3-7.
OPERATION
3-5
Advertisement
Table of Contents
