Seed Meter Adjustment - Landoll BRILLION TURFMAKER II SL Operator's Manual

MAINTENANCE

Seed Meter Adjustment

IMPORTANT
The Clutch must be disengaged when Seed Shafts
are turned manually for Calibration.
IMPORTANT
All the Seed Meters MUST BE CLOSED!
All Seed Meters must be set the same to ensure seeding
uniformity. To check, set the Seed Rate Adjusting Nut to
0-A. The "A" on the Seed Rate Adjusting Nut is
positioned over the "0" (the nut covers half of the"0") and
snug against the Bearing. See Figures 4-6 and 4-7.
Figure 4-6: Front Seed Box Rate Adjuster
Figure 4-7: Rear Seed Box Rate Adjuster
4-8
All Seed Meters should be closed. Seed Meter Feed
Shutoff against Seed Meter Cup Star Washer in Seed
Meter Cup. Figure 4-8. If not, there are three
adjustments to make as needed.
Figure 4-8: Seed Meter Feed Shutoff
IMPORTANT
Ensure that the Seed Shaft can turn freely without
any binding when the Seed Meters are open or
closed after servicing. Seed Box with Large Seed
Meters you may need to make adjustments to the
Seed Meter Supports at each Seed Meter Cup.
Figure 4-9.
Figure 4-9: Seed Meter Supports
9K998