Inner Wing Frames; Wing Gauge Wheel Installation - Landoll 9650FH Operator's Manual

ASSEMBLY INSTRUCTIONS

Inner Wing Frames

1. Attach inner wing frames to center frame using 1-1/4
flange bearings, flat washers, 1-1/4 x 6-1/8 pin and
5/16 x 2-1/2 spring slotted pins
2. Support the outer ends of the inner wing frames with
stands approximately 36" tall.
3. Remove any shank assemblies or extensions that
have been turned around or mounted inside the
frame for shipping, and reposition. (SEE PAGE 2-8)
shank placement.
4. Connect the radius rod to the cylinder lift arm, and
the cylinder ends which have been disconnected fro
shipping.
5. Install the 6-bolt tire/wheel assemblies on the inner
wing lift assembly.
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward.
3-10
See Figure 3-5.

Wing Gauge Wheel Installation

1. Remove the shipping u-bolts and nuts from front of
the gauge wheel extension mounts
2. Attach the gauge wheel assemblies to the front of the
center frame with 3/4 x 5-1/2 bolts and 3/4 locknuts.
3. Connect the radius rod assembly to the front of the
gauge wheel lift tube with the installed 1 x 7-1/2 bolts
and 1 locknut. Connect the front of the radius rod
assembly to the top of the gauge wheel links with 1 x
7-1/2 bolt and 1 locknut. Initially set the radius rod
assembly to 21" centers.
4. Install 6-bolt tire/wheel assemblies on the gauge
wheel assemblies.
See Figure 3-5.
F-1090-1120