Table of Contents
Advertisement
ASSEMBLY
3Pt Seeder Assembly
When shipped, Seeder comes assembled except for
Lights and 3Pt Hitch.
1. Support Seeder Assembly with a hoist or by similar
means capable of supporting its weight without
tipping.
2. Center 3Pt Hitch Assembly in relationship with the
Seed Box Center Bracket. Attach 3Pt Hitch to Seeder
Frame Tube with 5/8-11 U-Bolts, Lock Washers and
Nuts. See Figure 2-4.
3. Install Manual Holder to 3Pt Hitch with Hose Clamps.
4. 8Ft and 10Ft Seeders, Install SMV Support to Seed
Box Center Bracket with 3/8-16 x 1-1/2 Bolts, Flat
Washers, Lock Washers, and Nuts. See Figure 2-1.
Figure 2-1: SMV Support
Do not disengage Parking Pin unless Seeder is
fully attached to a Tractor. Seeder may be
rear-heavy and tip backward on frame.
5. Be sure Parking Pin is locking Rear Roller down and
raise the Seeder. See Figure 2-2.
2-2
CAUTION
Figure 2-2: Parking Pin Engaged
6. On the right side of the Seeder Frame, in a similar
position as the Parking Pin, remove the 5/8-11
Shipping Bolt that also locks the Rear Roller down.
See Figure 2-3.
Figure 2-3: Shipping Bolt
9K998
Advertisement
Table of Contents
