Table of Contents
Advertisement
ASSEMBLY
Figure 2-47: Deflector Flipped
11. Remove the Mounting Plate Hardware and slide the
LH Seed Box far enough to the right to remove the
Mounting Plate from the Seed Box and
Transmission. Complete removal of the Seed Box is
not required, the Seed Shaft will slide in the 37 Tooth
Sprocket and Bearing. Remove the Single Box
Mounting Plate and replace it with a Double Box
Mounting Plate on the Transmission and LH Seed
Box ensuring that the Seed Shaft is aligned and free
to rotate. Tighten Hardware.
12. Support LH Rear Seed Box. Align and insert Rear
Seed Box 3/8" Square Seed Shaft into Transmission
Drive Tube. Seed Shaft should be free to rotate.See
Figure 2-48.
2-32
Figure 2-48: Rear Box Seed Shaft
13. Assemble the LH Rear Seed Box to the
Transmission Double Box Mounting Plate with two
1/2-13 x 1-1/4 Bolts and a 3/8-16 x 1-1/4 Bolt, Flat
Washers, Lock Washers and Nuts. Tighten
Hardware.
14. Position Double Box Center Bracket against LH
Front and LH Rear Seed Boxes.
15. While supporting the RH Front Seed Box, position
Seed Box against Double Box Center Bracket.
Assemble Seed Boxes and Center Bracket together
with Hardware but do not tighten at this time.
16. Support RH Rear Seed Box and position Seed Box
against Double Box Center Bracket. Assemble Seed
Boxes and Center Bracket together with two 1/2-13 x
1-3/4 Bolts and a 3/8-16 x 1-1/2 Bolt, Flat Washers
and Lock Washers and Nuts. Do not tighten at this
time.
17. Assemble RH Double Box Support onto RH Front
Seed Box with Hardware but so not tighten at this
time.
18. Assemble RH Rear Seed Box onto RH Double Box
Support with two 1/2-13 X 1-1/4 Bolts and a 3/8-16 x
1 Bolt, Flat Washers, Lock Washers and Nuts. Do
not tighten at this time.
19. Turn the RH Front Seed Box Seed Shafts into the LH
Seed Shafts.
20. Turn the RH Rear Seed Box Seed Shafts into the LH
Seed Shafts. Do not tighten Rear Seed Box Feed
Roll Coupler at this time.
9K998
Advertisement
Table of Contents
