Table of Contents
Advertisement
Rear Seed Box Installation After
01/2020 – Optional
1. Engage Parking Pin on 3Pt Models. Lower Seeder
and empty Seed Boxes.
2. Disconnect Acre Meter and Warning Lamps.
3. 8 and 10Ft Models, remove RH and LH Light
Brackets.
4. 12Ft Models, remove Turnbuckles from Seed Box
RH Support, Center Bracket and LH Mount Plate.
5. On the side of the Transmission by the Electric
Clutch, loosen the Transmission #40 Drive Chain
Idler Sprocket Nut to disengage Drive Chain tension.
See Figure 2-34.
Figure 2-34: Loosen Idler Sprocket
6. Remove Seed Shaft Seed Rate Adjusting Nut. Do
Not loosen 1/2-13 Locknuts at the end of the Seed
Rate Adjusting Screw. See Figure 2-35.
Figure 2-35: Front Box Seed Rate Adjuster
9K998
7. Remove Seed Rate Adjuster Bearing Carrier Plate
with Bearing still assembled to it, from the Seed Box
RH Support and Seed Rate Adjusting Screw.
8. At the center of the Seeder where the RH and LH
Hex Seed Shafts come together, remove Seed Shaft
Coupling and unscrew RH Seed Shaft from LH Seed
Shaft. See Figure 2-36.
Figure 2-36: Front Box Seed Shaft Coupler
9. Support RH and LH Seed Boxes by using the hole in
the Dividers inside the Seed Box. Remove Seed Box
RH Support, RH Seed Box and Seed Box Center
Bracket.
10. Remove Rear Deflectors. Turn Rear Deflectors
around so that the lip angles rearward. Re-install
Rear Deflectors. See Figure 2-37.
Figure 2-37: Deflector Flipped
ASSEMBLY
2-27
Advertisement
Table of Contents
