Table of Contents
Advertisement
Seed Shaft Sensor Console with
Clutch Control - Optional
Basic Operation:
During normal operation the Console LED for the Seed
Shaft will not be illuminated. The Shaft Sensor will be
activated by the Magnet Wheel Assembly installed on the
Seed Shaft being monitored. The Shaft Sensor is a
standard Loup Shaft Sensor, set to 20 second delay
timing. When no signal is detected for 20 seconds by the
sensor, the LED in the Console will illuminate and the
audible alarm will sound indicating a fault. The alarm will
become silent after 30 seconds and will not sound again
until the Seed Shaft returns to a fully functional condition.
NOTE
If Shaft Sensor stall alarm occurs, be aware that the
seeder has not been planting for 20 seconds.
The Clutch Master toggle switch allows you to go from
"SEED" to "NO SEED" operations.
General Operation
1. The minimum horsepower requirements are typically
6-8 horsepower per foot. This will vary widely due to
speed, moisture, and types of soils. Local dealers can
help in making recommendations for your areas. For
3-PT Hitch Models size tractor by 3-PT Hitch
Capacity.
2. Operating speed is typically 3-6 mph. Excessive
speed can result in undesirable germination, seeder
bouncing, or other unpredictable results. Reduce
speed in rocky conditions to prevent wheel breakage.
Transporting the Seeder
1. Check and follow all federal, state, and local
requirements before transporting the Seeder.
2. The Seeder should be transported only by tractor
required for field operation. The machine weight
should not exceed more than 1.5 times the tractor
weight. Maximum transport speed for the Seeder is
20 mph for the machine.
Excessive speed may result in loss of control of
the tractor and machine, reduced braking ability,
or failure of the machine tire or structure. Do not
exceed the machines maximum specified ground
speed regardless of the capability of the
maximum tractor speed.
1P342-0621
CAUTION
3. When towing equipment in combination, the
maximum equipment ground speed shall be limited
to the lowest specified ground speed of any of the
towed machines.
Maximum transport speed shall be the lesser of
travel speed specified in the operator's manual,
speed identification symbol, information sign of
towed equipment, or limit of road conditions.
• EXAMPLE: If the tractor is capable of 25 mph, the
first implement has a SIS for 19 mph, and the last
implement's operator's manual states its specified
ground speed is 15 mph, the towed equipment
combination ground speed limitation is 15 mph.
4. Slow down when driving on rough roads. Reduce
speed when turning, or on curves and slopes to
avoid tipping. Equipment altered other than the place
of manufacture may reduce the maximum transport
speed. Additional weight, added tanks, harrowing
attachments, etc. may reduce machine load carrying
capabilities.
5. A safety chain is provided with the implement to
insure safe transport.
• The safety chain should have a tensile strength
equal to or greater than the gross weight of the
implement. The chain is attached to the lower hitch
clevis hole with two flat washers between the
clamp plates to assure a tight connection. Always
use a 1" diameter Grade 8 bolt for this connection.
• Attach the safety chain to the tractor drawbar.
Provide only enough slack in the chain for turning.
Do not use an intermediate chain support as the
attaching point for the chain on the tractor. Do not
pull the implement by the safety chain
• Regularly inspect the safety chain for worn,
stretched, or broken links and ends. Replace the
safety chain if it is damaged or deformed in any
way.
6. Check that tires are of proper size, load rating, and
inflated to manufacture specifications before
transporting. Check wheel lug bolts to ensure
tightness.
7. Know the transport heights and widths of the unit
before transporting. Use caution when transporting
near bridges and power lines.
Electrocution can occur without direct contact.
8. Use provided pins that properly fits the Lift Arms or
Quick Hitch and Machine Hitch.
• Check to see that the tractor hitch capacity is rated
to carry the Laden Mass of the Seeder.
OPERATION
WARNING
3-17
Hide quick links:
Advertisement
Table of Contents
