Led Lamp And Harness Installation - Landoll Brillion WFPD38-52 Operator's Manual

LED Lamp and Harness Installation

NOTE
See Figures 2-17 and 2-18 for part placement and
reference.
1. Attach a Red LED Lamp to both Light Brackets
located on top of the rear frame tube, using 1/4-20 x
1-1/2 Bolts and Locknuts. Ensure the lens faces
rearward.
2. Attach the LH and RH Warning Lamp Brackets to the
front of the front frame tube approximately 18" from
the inside of the bearing hangers using 5/8-11
U-Bolts and Flanged Locknuts and tighten. See
Figures 2-19 or 2-20.
3. Slide a Warning Lamp Bracket into each of the RH
and LH Warning Lamp Brackets. Attach with 1/2-13
U-Bolts and Flanged Locknuts. Do not fully tighten at
this time.
4. Attach the Light Module on top of the Light Module
Bracket located on top of the front frame tube, using
1/4-20 x 1-1/2 Bolts and Locknuts.
5. Route the flat end of the 7 pin harness inside and
through the right side of the Drawbar A-Frame. Plug
into the Light Module. Route the other end along the
drawbar with the hydraulic hoses up to the tractor.
IMPORTANT
Connectors with Green Tape is right side and Yellow
Tape is left side.
6. Layout the LED Lamp Harness. Note that the cords
are marked left (Yellow Tape) and right (Green Tape).
Attach the harness to the Light Module
7. Route the 2 prong cords along the left and right top of
the front frame tube and up through the Warning
Lamp Bracket. Ensure 2 prong cord sticks out the slot
opening at the top of the bracket. Plug Amber LED
Lamp into harness and secure lamp using 1/4-20 x
1-1/2 Bolts and Locknuts
8. Adjust the Warning Lamp Bracket so the LED Lamp
can be easily seen from the rear of the machine.
Tighten 1/2-13 U-Bolt and Flanged Locknuts. On the
50' and 52' models the Amber LED Lamp on the
Warning Lamp Brackets must not be greater that 16"
from the folded wing outer edge. See Figure 2-20.
9. On the 50' and 52' models place an Amber Reflective
Decal on the front side on each Warning Lamp
Bracket. Place a Red Reflective and an Orange
Decal on the rear on each Warning Lamp Bracket.
See Figure 2-20.
F-661R4
10. Route the "Right" 3 prong cord across the top of inner
frame tube to the rear frame, Plug the harness into
the right Red LED Lamp. Route the "Left" 3 prong
cord along the top of front frame, then across the left
inner frame, Plug the harness into the left Red LED
Lamp.
11. Secure both harnesses with tie straps, making sure
to leave enough slack, where the drawbar meets the
frame, to allow the machine raise and lower. Secure
LED lamp harness molded union to the top of the
front frame tube using Tie Straps. Bundle and secure
any excess cord with tie straps.
12. Raise, lower, fold and unfold machine to check for
proper clearance, adjust accordingly.
IMPORTANT
All cords must be firmly attached to the machine
frame members, or hydraulic lines, so they don't sag
or become torn loose by field debris. Use the cable
and hoses ties provided.
ASSEMBLY
2-21