Wheel Lift Installation - Landoll 2211 Operator's Manual

Wheel Lift Installation

1. Retract the 3-1/2 x 16 lift cylinders on both sides
before installing the radius rod.
2. Install radius rod assembly to the frame assembly
using 1-8 x 4 hex head cap screws and hex lock
nuts. Adjust the radius rod to fit with the cylinders
fully retracted (See Figure 3-5.)
NOTE
Once radius rod is installed, be sure to tighten jam nuts.
3. No further adjustment should be required. Any other
adjustment can severely damage frame and lift
components.
4. Assemble the tires to the hubs. 2211-9/11 models
use 12.5L x 15 Farm Highway tires. 2211-13/15
models use 380/55R -16.5 tires. Tighten wheel bolts
evenly to assure proper wheel alignment. Wheel
bolts should be tightened to 90 ft-lbs of torque. The
hoist can then be removed.
5. Inflate the tire as recommended by the manufacturer.
ASSEMBLY INSTRUCTIONS
3-9