Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Assembly Preparation
1. Hook up the Zone Commander to a tractor using the
three-point hitch.
2.
Raise the unit about 36" and place stands under the
main frame to prevent accidental lowering.
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.
Jackstand Installation
1. Remove jackstand(s) from frame.
2. Remove rigid gauge adjustment pin and 3/16 hair pin
cotter from outer jackstand tube.
3. Insert jackstand through bottom of outer jackstand
tube and pin at desired level with rigid gauge
adjustment pin and 3/16 hair pin cotter (See
Figure 3-1.)
3-2
WARNING
Figure 3-1: 2511 Series Parts Identification
SMV Bracket Installation
1. Attach the SMV mounting bracket at a point where
emblem is visible from rear of machine, using u-bolt
and 5/8-11 flange head serrated nuts (See
Figure 3-1.)
2. Attach SMV emblem to top of SMV mounting bracket
using 1/4-20 x 1 hex head cap screws, flat washers,
and hex lock nuts (See Figure 3-14.)
Tire and Wheel Assembly
1. All hubs and spindles come already assembled from
the factory. Mount the tire and wheel assembly onto
the hubs.
F-758R0
Advertisement
Table of Contents
