Table of Contents
Advertisement
ASSEMBLY
Frame and Transport Axle Assembly
1. Select a smooth, level area that can be reached by a
hoist or lift truck.
2. Place the Center Frame on supports, approximately
36 inches high and rated for 2,000 lbs. or higher.
NOTE
The Plastic Bearing Inserts are maintenance free and
require no grease.
3. Place two Bearing Inserts into two Bearing Halves.
Position one set under and one on top of the
transport axle pipe near the center of the Transport
Axle Arm. Slide two 5/8-11 x 13 Bolts down through
the frame holes into both halves. Attach with Flat
Washers and Locknuts.
4. Repeat for the left, right and center bearing halves.
Tighten all hardware.
5. Attach the Wing Support to the rear of the frame
using 1/2-13 x 1 3/4" Bolts, Flat Washers and
Locknuts.
6. Place the 1-3/4 x 9 Transport Lock onto the storage
lug on the left side of the rear frame. Secure with
Clevis Pin and Hairpin Cotter.
7. Place the 1-3/4 x 20 Transport Lock onto the storage
lug on the right side of the rear frame. Secure with
Clevis Pin and Hairpin Cotter.
8. Install the base end of the 4 x 20 Hydraulic Cylinder
to the Frame Lug and the rod end of the cylinder to
the Transport Axle Lug with the 1 x 6 pin. Secure with
Flat Washers and 5/16 x 2 Slotted Pin.
9. Tighten all hardware to the recommended torques.
See Page 4-1.
Tire Installation
Install a Tire Assembly onto each Transport Axle Hub,
using eight 9/16-18 x 1-1/8 wheel bolts. Torque to 90-100
ft/lbs.
Leave supports under frame to support the machine in
case of weight shift while adding components.
Use a torque wrench to assure proper torque.
Insufficient torque can cause stud breakage and
damage the wheel pilots. Over torque can
overstress the studs and strip the threads.
NOTE
All tire/wheel assemblies are mounted with the valve
stem facing outward from Hub and Spindle.
2-2
WARNING
F-661R4
Advertisement
Table of Contents
