Table of Contents
Advertisement
Wheel Lift Installation
1. Position the lift under the lift bearing mount brackets
on the frame assembly (See Figure 3-2.)
IMPORTANT
The wheel lift arms should point toward the rear of
the machine with the cylinder anchors facing up.
2. Install the lift to the frame assembly using 3/4-10 x 2
hex head cap screws, lift bearing caps, 4" bearings,
and hex lock nuts.
3. Insert 1-5/8 x 1-1/4 x 1 bushing into each cylinder
mount plate of the shank lift.
4. Attach base end of the 3-1/2 x 16 hydraulic cylinder
to the cylinder anchor plates of the frame assembly
using roll pin and clevis pin supplied with the cylinder.
ASSEMBLY INSTRUCTIONS
5. Attach rod end of each 3-1/2 x 16 hydraulic cylinder
to the lift using roll pin and clevis pin supplied with
the cylinder.
o
6. Install 90
adapters in each port of both 3-1/2 x 16
cylinders.
IMPORTANT
o
Do not use 90
adapters with restrictors in ports of
3-1/2 x 16 hydraulic cylinders.
7. Attach leveler tube to leveler mount plates on the lift
using hitch pin, 1-8 hex lock nut, and 1/2 x 2-1/4
slotted spring pin.
8. Assemble the tires to the hubs. Tighten wheel bolts
evenly to assure proper wheel alignment. Wheel
bolts should be tightened to 90 ft.-lbs of torque. The
hoist can then be removed.
9. Inflate the tire as recommended by the manufacturer.
3-5
Advertisement
Table of Contents
