Table of Contents
Advertisement
ASSEMBLY
Drawbar Installation
1. Remove 3-Point Hitch Assembly and Link Weldment.
2. Attach Drawbar to the outside of the Frame with two
1-8 X 2-1/2" Capscrews, Bushings, Flat Washers and
Lock Nuts. See Figure 3-1.
3. Install Drawbar Link's slotted end between the Frame
Mast and place the Transport Lock Straps on each
side of the Mast. Secure in place with 1" X 2-1/2"
Clevis Pin and 3/16" x 2" Cotter Pin. Install Bushing
End onto the Drawbar with 3/4" x 3-7/8" Pin and two
5/32" x 1-1/2" Cotter Pins.
4. Install the second 1" x 2-1/2" Clevis Pin and Klik Pin
into the bottom hole of the Straps for Operation or
into the second hole from the bottom of the Straps
and thru the slot in the Drawbar Link for Transport.
5. Attach Safety Chain with 3/4-10 X 2-1/4" Capscrew,
Flat Washers and Lock Nut.
6. Install Jack.
Rockshaft Installation
1. Fasten Rockshaft to Frame end plates with 1/2-13 x
1-1/4" Capscrews and Lock Nuts.
2. Align Cylinder Mount lug with Rockshaft lug. Attach
Cylinder Mount onto Frame tube with 1/2-13 U-bolts
and Lock nuts.
3. Install either the Hydraulic Cylinder, See Figure 3-2.
or the Ratchet Jack, See Figure 3-3. between the two
Lugs. If installing a Hydraulic Cylinder also attach the
manual Transport Lock to the rod end of Cylinder
with 1" x 3-5/8" Pin and 3/16 x 2 Cotter Pins.
4. Bent Pin and Hair Pin Cotter are used to Lock the
Transport Lock in position during operation and
transport. For operation the bent pin goes thru top
hole on rockshaft cylinder lug and for transport bent
pin goes under cylinder rod. See Fig 3-2.
Hub and Spindle, Wheel and Tire
Installation
1. Install a Hub and Spindle into each Rockshaft sleeve.
Secure with 3/8-16 x 2-1/2 Capscrew and Lock Nut.
2. Mount a Wheel and Tire Assembly onto each hub
with 1/2-20 x 1" Wheel Bolt. See Fig 3-2.
3-2
Figure 3-2: Rockshaft Installation
Figure 3-3: Ratchet Jack Installation
2P102
Advertisement
Table of Contents
