With The Help Of The "Create Myconfig" Software; Reinstallation With Create Myconfig - Siemens SINUMERIK 840D sl Commissioning Manual

New installation / upgrading

12.2 With the help of the "Create MyConfig" software

12.2 With the help of the "Create MyConfig" software
Precondition
The "Create MyConfig" software on PG/PC is the precondition to configure a package.
Basic procedure
The descriptions for automatically reinstalling/upgrading using Create MyConfig include the
basic steps for configuring and subsequent automatic execution at the control system. The
"Create MyConfig" software has integrated online help.
12.2.1

Reinstallation with Create MyConfig

Preconditions
The following preconditions must be met for the CompactFlash card of the NCU:
● The CompactFlash card of the NCU is empty or contains executable NCU software.
If any CNC software and possibly irrelevant user data are on the CompactFlash card, then
these are lost when the software is newly installed.
● You have a <name>.tgz file (cnc-sw.tgz ) with the actual software.
● You want to initiate a new installation of the NCU via a USB FlashDrive.
● If the CompactFlash card is empty or does not contain executable CNC software, you need
a USB FlashDrive with installed "NCU Service System".
Operating sequence
In order to configure a package for the reinstallation of the CNC software with "Create MyConfig
Expert":
1. Start the "Create MyConfig Expert" software.
With this software you configure an Installer package that initiates a reinstallation from the
USB Flashdrive to the CompactFlash card of the NCU.
2. Create a new project via the menu "Project" > "New".
372
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA