Siemens SINUMERIK 840D sl Commissioning Manual page 379

8. Create a package "<name>.usz" via the menu "File" > "Transfer" > "Linux package (NCU)
and select as target path the root directory of the USB FlashDrive.
Create MyConfig Expert saves the project, performs a validation run, creates and saves the
package under the specified target path.
A "<name>.usz" package is then located in the root directory of the USB FlashDrive.
Depending on the configuration in the previous step, the "<name>.tgz" file is also located
next to the package.
9. Insert the USB FlashDrive into a USB socket (X125 or X135) of the NCU.
10.Switch the control system off and on again.
Provided that when configuring you configured the "Edit mode of all dialogs" → "Automatic",
then the package is automatically executed when the control system boots-up. The CNC
software has been upgraded and all data is available again after the package has been
completed on the NCU.
A logbook about the activities that have been performed can be saved. The logbook
documents all activities performed during the upgrade.
11.Switch-off the control system.
12.Remove the USB FlashDrive.
13.The machine is ready for operation again after switch-on.
Optional additional functions when upgrading the CNC software
In the same package - after the CNC software has been installed - the following actions can be
optionally configured, which can either run completely automatically or conditionally at the
machine:
● Manipulation of display machine data
● Manipulation of individual NC and drive data
● Loading the PLC program or from individual blocks
● Installing software
● Copying, deleting and manipulating files on the CompactFlash card
● Conditional execution of actions, executing, deleting, copying and manipulating
● Messages and interactions to the operator
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
12.2 With the help of the "Create MyConfig" software
New installation / upgrading
379