Keysight InfiniiVision M9241A Scpi Programmer's Manual page 5

Pxie oscilloscopes
Hide thumbs Also See for InfiniiVision M9241A:
Table of Contents

Advertisement

The command descriptions in this reference show upper and lowercase characters.
For example, :AUToscale indicates that the entire command name is :AUTOSCALE.
The short form, :AUT, is also accepted by the oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
Finally, there is a chapter that contains programming examples:
See Also
• For more information on using the SICL, VISA, and VISA COM libraries in
• For information on controller PC interface configuration, see the
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
Chapter
28, ":SEARch Commands," starting on page 933, describes commands
that control oscilloscope functions associated with searching for waveform
events.
Chapter
29, ":SYSTem Commands," starting on page 1011, describes
commands that control basic system functions of the oscilloscope.
Chapter
30, ":TIMebase Commands," starting on page 1039, describes
commands that control all horizontal sweep functions.
Chapter
31, ":TRIGger Commands," starting on page 1053, describes
commands that control the trigger modes and parameters for each trigger
type.
Chapter
32, ":WAVeform Commands," starting on page 1157, describes
commands that provide access to waveform data.
Chapter
33, ":WGEN<w> Commands," starting on page 1193, describes
commands that control waveform generator (Option WGN) functions and
parameters.
Chapter
34, ":WMEMory<r> Commands," starting on page 1239, describes
commands that control reference waveforms.
Chapter
35, "Obsolete and Discontinued Commands," starting on page 1249,
describes obsolete commands which still work but have been replaced by
newer commands and discontinued commands which are no longer supported.
Chapter
36, "Error Messages," starting on page 1293, lists the instrument error
messages that can occur while programming the oscilloscope.
Chapter
37, "Status Reporting," starting on page 1301, describes the
oscilloscope's status registers and how to check the status of the instrument.
Chapter
38, "Synchronizing Acquisitions," starting on page 1333, describes
how to wait for acquisitions to complete before querying measurement results
or performing other operations with the captured data.
Chapter
39, "More About Oscilloscope Commands," starting on page 1353,
contains additional information about oscilloscope programming commands.
Chapter
40, "Programming Examples," starting on page 1363.
general, see the documentation that comes with the Keysight IO Libraries
Suite.
documentation for the interface card used (for example, the Keysight 82350B
GPIB interface).
5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the InfiniiVision M9241A and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Infiniivision m9242aInfiniivision m9243a

Table of Contents