Sbus<N>:Nrz:logic - Keysight InfiniiVision M9241A Scpi Programmer's Manual

27
:SBUS<n> Commands
:SBUS<n>:NRZ:LOGic
Command Syntax
:SBUS<n>:NRZ:LOGic <logic>
<logic> ::= {HIGH | LOW}
The :SBUS<n>:NRZ:LOGic command specifies the polarity of the NRZ signal:
• HIGH — specifies that a positive voltage is used to encode a bit value of logic 1
• LOW — specifies that a negative voltage is used to encode a bit value of logic 1.
Query Syntax
:SBUS<n>:NRZ:LOGic?
The :SBUS<n>:NRZ:LOGic? query returns the polarity setting.
Return Format
<logic><NL>
<logic> ::= {HIGH | LOW}
See Also •
•
•
•
858
(see page 1354)
(and a negative voltage encodes a bit value of logic 0).
":SBUS<n>:NRZ:BASE"
":SBUS<n>:NRZ:BITorder"
":SBUS<n>:NRZ:IDLE:BITS"
":SBUS<n>:NRZ:IDLE:STATe"
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
on page 849
on page 851
on page 856
on page 857