Sbus<N>:Uart:parity - Keysight InfiniiVision M9241A Scpi Programmer's Manual

27
:SBUS<n> Commands
:SBUS<n>:UART:PARity
Command Syntax
:SBUS<n>:UART:PARity <parity>
<parity> ::= {EVEN | ODD | NONE}
The :SBUS<n>:UART:PARity command selects the parity to be used with each
message "byte" for the serial decoder and/or trigger when in UART mode.
Query Syntax
:SBUS<n>:UART:PARity?
The :SBUS<n>:UART:PARity? query returns the current UART parity setting.
Return Format
<parity><NL>
<parity> ::= {EVEN | ODD | NONE}
See Also •
•
•
910
(see page 1354)
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 1066
":SBUS<n>:UART:TRIGger:TYPE"
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
on page 1053
on page 919