Recall:dbc[:Start] - Keysight InfiniiVision M9241A Scpi Programmer's Manual

25
:RECall Commands

:RECall:DBC[:STARt]

Command Syntax
:RECall:DBC[:STARt] [<file_name>] [, <serialbus>]
<file_name> ::= quoted ASCII string
<serialbus> ::= {SBUS<n>}
<n> ::= 1 to (# of serial bus) in NR1 format
The :RECall:DBC[:STARt] command loads a CAN DBC (communication database)
symbolic data file into the oscilloscope.
If a file extension is provided as part of a specified <file_name>, it must be ".dbc".
NOTE
The <serialbus> parameter specifies which serial decode waveform the CAN
symbolic data will be loaded for.
See Also •
•
•
•
•
•
•
•
•
•
684
(see page 1354)
"Introduction to :RECall Commands"
":RECall:FILename" on page 685
":SBUS<n>:CAN:TRIGger"
":SBUS<n>:CAN:TRIGger:SYMBolic:MESSage"
":SBUS<n>:CAN:TRIGger:SYMBolic:SIGNal"
":SBUS<n>:CAN:TRIGger:SYMBolic:VALue"
":SEARch:SERial:CAN:MODE"
":SEARch:SERial:CAN:SYMBolic:MESSage"
":SEARch:SERial:CAN:SYMBolic:SIGNal"
":SEARch:SERial:CAN:SYMBolic:VALue"
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
on page 682
on page 762
on page 772
on page 773
on page 774
on page 971
on page 977
on page 978
on page 979