Operegister:condition (Operation Status Condition Register) - Keysight InfiniiVision M9241A Scpi Programmer's Manual

:OPERegister:CONDition (Operation Status Condition Register)

Query Syntax
:OPERegister:CONDition?
The :OPERegister:CONDition? query returns the integer value contained in the
Operation Status Condition Register.
From Hardware
Event Registers
+
OR
To OPER bit in
Status Byte
Register
Table 79 Operation Status Condition Register
Bit
14
13
12
11
10
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
(see page 1354)
From Overload From Mask Test
Event Registers Event Registers
IOF IOC HWE
OVLR MTE
14 13 12 11 9
IOF IOC HWE OVLR MTE
14 13 12 11 10 9
Name Description
IOF IO Operation Failed
IOC IO Operation Complete
HWE Hardware Event
OVLR Overload
--- ---
Arm
AER? Set if remote user interface is enabled
Reg
Run bit set if oscilloscope not stopped
RUI
Wait
Run
Trig
Enab
5 4 3
Wait RUI
Run
Trig
Enab
8 7 6 5 4 3 2
When Set (1 = High = True), Ind icates:
Event only when something causes the IO
operation to fail, like disconnecting a USB
device or interrupting the operation from the
oscilloscope's front panel.
Event when any IO operation completes. IO
operations are any remote data request using
any interface (USB, LAN, or GPIB). For example,
if you connect to an oscilloscope using the USB
interface and then request waveform data, the
IOC bit will be set when the IO operation
completes.
Event when hard ware event occurs.
A 50Ω input overload has occurred.
(Not used.)
Root (:) Commands
:OPERegister:CONDition?
Operation Status Condition Register
:OPERegister[:EVENt]?
Operation Status Event Register
1 0
:OPEE
:OPEE?
Operation Status Enable
(Mask) Register
7
223