Counter:totalize:slope - Keysight InfiniiVision M9241A Scpi Programmer's Manual

11
:COUNter Commands

:COUNter:TOTalize:SLOPe

Command Syntax
:COUNter:TOTalize:SLOPe <slope>
<slope> ::= {{NEGative | FALLing} | {POSitive | RISing}}
The :COUNter:TOTalize:SLOPe command specifies whether positive or negative
edges are counted.
Query Syntax
:COUNter:TOTalize:SLOPe?
The :COUNter:TOTalize:SLOPe? query returns the currently set slope specification.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also •
•
•
•
•
•
•
•
•
306
(see page 1354)
":COUNter:CURRent"
":COUNter:ENABle" on page 298
":COUNter:MODE" on page 299
":COUNter:NDIGits" on page 300
":COUNter:SOURce" on page 301
":COUNter:TOTalize:CLEar"
":COUNter:TOTalize:GATE:ENABle"
":COUNter:TOTalize:GATE:POLarity"
":COUNter:TOTalize:GATE:SOURce"
Keysight InfiniiVision M9241/42/43A PXIe Oscilloscopes SCPI Programmer's Guide
on page 297
on page 302
on page 303
on page 304
on page 305