Fluke Calibration 4322-SYS-NAVAIR Service Manual page 64

4322
Service Manual
10. Connect the cable from (J14) of main PCA and connect (P4) and (P5) on power
11. Install the six screws and washers () that secure the electronics cover/power
12. Install the four screws and washers () that secure the handles to the control panel
13. Install the two screws () that secure the control panel () to the chassis.
14. Use the instructions in "Pressure Transducers and Barometer" on page 4-26 to
4-12
f. Connect the CPS isolation valve VH3 cable to (J8) on the main PCA.
supply to allow for installation of the electronics cover/power supplies
(see Figure 4-5).
supplies ().
().
remove the pressure transducers and barometer.