The Product Manual Set - Fluke Calibration 4322-SYS-NAVAIR Service Manual

•
Before using this equipment to generate or apply pressure,
ensure integrity of all components to be pressurized and
that they are rated to adequate working pressure.
•
Do not put the Product where access to the mains power
cord is blocked.
•
Do not use test leads if they are damaged. Examine the test
leads for damaged insulation and measure a known voltage.
•
Do not exceed the Measurement Category (CAT) rating of
the lowest rated individual component of a Product, probe,
or accessory.
•
Keep fingers behind the finger guards on the probes.
•
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
•
Do not touch voltages > 30 V ac rms, 42 V ac peak, or
60 V dc.
•
Do not use the Product around explosive gas.

The Product Manual Set

The Calibrator includes an Operators Manual and a Service Manual. Both manuals are
online at
www.flukecal.com
Not all available components are included in every configuration of a 4322
system. Both manuals assume model 4322-SYS-NAVAIR, which includes all
major components available, except for the 4322-REM Handheld Control,
which is ordered separately.
•
The 4322 Operators Manual contains basic system and feature information,
operation instructions, and basic user maintenance and troubleshooting information.
•
This 4322 Service Manual contains service, calibration, and repair information and
instructions.
and on a CD in the Accessory Kit.
Note
Introduction and Specifications
The Product Manual Set
1
1-5