Side Glue Amount Adjustment (Far Side) - Horizon Fitness BQ-270 Manual

4-9 Side Glue Amount Adjustment (Far Side)

If the side glue is not applied on the far side even there
is glue on the side gluing roller, you should adjust the
position of the side gluing roller on the far side.
CAUTION
Wear thick gloves during this operation.
The melt tank may be heated to 200
degrees Celsius (400 Fahrenheit) and may
cause severe skin burns.
Turn off the power and open the left
safety cover.
Loosen the locking screw of the
positioning plate and turn the plate
counterclockwise.
- Insert an Allen wrench into the hole on the
plate and rotate the plate.
- The side gluing roller on the far side will move
out.
Side Gluing Roller (far side)
Allen Wrench
- After adjustment, tighten the locking screw.
If there is still not enough glue on the side gluing roller,
adjust the glue amount on the side gluing roller. See
the instructions which follow.
Locking Screw
Positioning Plate
62