Adding More Glue - Horizon Fitness BQ-270 Manual

3-12 Adding More Glue

This section explains how to refill the glue in the melt
tank.
The lower limit of the glue level is 8 mm (0.31") lower
position below the upper limit line.
Do not run the machine in the condition that the glue
level is under the lower limit line.
.
WARNING
Do not touch the melt tank after the power
is turned on. The melt tank is heated to 200
degrees Celsius (400 Fahrenheit) and may
cause severe skin burn.
Open the left safety cover.
Add glue into the melt tank.
- Add glue when the glue level come to the
lower edge of the glue level plate. If the glue
level comes lower than the plate, it may dam-
age the gluing mechanism.
- Be careful that the glue level will not go over
the upper limit line when the glue is melted.
This will cause the glue to overflow.
Use type HM220 glue, made by Horizon.
Glue Level Upper Limit
Glue Feed Section
52
CAUTION
The glue level lowers while the application
roller is rotating. Check the glue amount
when the application roller stops.
Close the left safety cover.