Table of Contents
Advertisement
1 General
1 - 4 Setting the QC-S30
2
Setting the Overlap Amount
1 - 4 -
Turn on the power switch while pressing the [Stop] button and the [Finisher /
Stacker Select] button together. Display shows the following figures.
[Stand Alone]
A
=
Overlap Amount
with Collator Only
Press the Start Button
[Stand Alone]
b
=
Overlap Amount
with SPF9/9A or MF-1
Press the Start Button
c
=
Double Feed
Detecting Time
Press the Start Button
d
=
Clutch Rotating Time
Press the Start Button
[Connected Collators]
E
=
Overlap Amount with
Collator Only
Press the Start Button
[Connected Collators]
F
=
Overlap Amount with
SPF9/9A or MF-1
Press the Start Button
G
=
Total Count
1
General
Press the button for one's place (rightmost button), and the value increases.
This increases the interval between each sheet.
Press the button for ten's place (second to rightmost button), and the value
0
direction
decreases. This decreases the interval between each sheet.
Press the button for one's place (rightmost button), and the value increases.
This decreases the interval between each sheet.
Press the button for ten's place (second to rightmost button), and the value
0
decreases. This increases the interval between each sheet.
direction
Press the button for one's place (rightmost button), and the value increases. This increases the detecting time of
the double feeding.
Press the button for ten's place (second to rightmost button), and the value decreases. This decreases
the detecting time of the double feeding.
Press the button for one's place (rightmost button), and the value increases. This increases the time that the feed
roller becomes [ON].
Press the button for ten's place (second to rightmost button), and the value decreases. This decreases the time that
the feed roller becomes [ON].
Press the button for one's place (rightmost button), and the value increases. This
increases the interval between sheet blocks from each tower.
Press the button for ten's place (second to rightmost button), and the value
0
direction
decreases. This decreases the interval between sheet blocks from each tower.
Press the button for one's place (rightmost button), and the value increases.
This decreases the interval between sheet blocks from each tower.
Press the button for ten's place (second to rightmost button), and the value
0
direction
decreases. This increases the interval between sheet blocks from each tower.
This indicates the total count. Display shows only four digits, so press the button for one's place (rightmost button)
and the button for thousand's place (leftmost button) to show the unindicated number.
Total count will be cleared when the button for one's place (rightmost button) is pressed while the [Finisher / Stacker
Select] button is pressed.
1 - 4 - 2 Setting the Overlap Amount
Q C - S 3 0 0
0
51041 10402A1
1-11
Advertisement
Table of Contents
