Melt Tank Section - Horizon Fitness BQ-270 Manual

1-3 Parts Descriptions

1-3-4 Melt Tank Section

Side Glue Roller
This drum is used to apply the glue
on the lower side of the book block.
Glue Amount Adjusting Plate
If too little glue is applied to the
side glue roller, or too much glue is
applied, adjust the glue amount by
moving this plate.
Adjust according to the glue
amount applied here.
Wiper 1
The distance of glue penetration
into the spine depends on the wiper
opening.
Application Drum 1
This drum is used to provide the
glue that penetrates into the spine.
Glue Temperature Adjusting Knob
The glue temperature can be adjusted from
120 to 180 . (248 to 356
Do not touch the melt tank after the power is turned on.
The melt tank is heated to 200 degrees Celsius (400
Fahrenheit) and may cause severe skin burn.
Wiper 2
Positioning Plate - Side Glue Roller (far side)
This plate is used to adjust the position of the side
glue roller on the far side of the machine. Turn the
plate counterclockwise, and the roller moves
forward to approach to the book block. (Normally
set to 0.)
)
CAUTION
Lubrication Point
Refer to [5-3] for details.
4
Glue Level Upper Limit
Keep the glue level lower
than this line.
The lower limit of the glue level
is 8 mm (0.31") lower position
below the upper limit line.
Application Drum 2
This drum is used to put the
glue on the book spine.
Scrape Roller
This roller scrapes the extra
glue off of the spine.
Glue Supply Section
Add more glue here when
the glue level is low.